MySENSORS WORKFLOW


READY TO MEASURE IN THE FASTEST WAY

One of the first things in most measurement campaigns is the planning and preparation of resources. How to do this efficiently?
A new workflow for your instrumentation turns your manual tasks into digital ones. This results in less manual work, fewer failures, enhanced sustainability, and higher productivity.



...

STORE SENSOR DATA

Collect required sensors in your sensor data base, the PAK Equipment Manager. Or select the CAN decoding information in the PAK Digital Bus Editor.
All information is automatically uploaded into PAK cloud.



...

TRANSFER SENSOR DATA

Sensor data and CAN decoding information will be automatically transferred to the PAK MKII or MicroQ frontend by a smart service.
Use PAK capture to visualize information and to apply sensors on-site to matching channels. PAK capture guides users in settings, sensor matching, and on-site signal checks.



...

MEASURE AND UPLOAD DATA

Once your data acquisition device is running, you can start recording data to the local SSD of the frontend wherever you are.
After finishing your measurement campaign connect your frontend to the network. A smart service will automatically upload all data into the specified data depot for further interaction.




PREREQUISITES


Software & Hardware requirements

Please note: Before you start trying the MySensors workflow, you need to register for this use case below!
Please read the tutorial (after login to the cloud) carefully, which will guide you through the use case step by step. For any further information, please contact us.


BENEFITS IN BRIEF

  • Less manual work
  • Automated processes
  • Better quality of measurements